Product Overview
Genuine Honda Front Suspension Bolt Kit – Honda Civic Type R EP3 2001-2005
When you rebuild the front suspension of an EP3 Civic Type R, the original bolts are often corroded, stretched or seized. This kit gathers the Genuine Honda front-end fasteners into one order, so you can refit arms, dampers and the subframe with fresh hardware.
What’s included
- 4 x front arm bolt (90118-S5A-000)
- 4 x front anti-roll bar bracket bolt (95701-10018-08)
- 4 x lower damper bolt (90119-S6M-Z01)
- 4 x lower damper nut (90382-SP0-003)
- 4 x subframe bolt (90175-S5A-000)
- 2 x rear lower brace bolt (90801-S5A-000)
- 2 x ABS sensor bolt, sensor side (95701-06016-08)
- 4 x ABS sensor bolt, plug side (95701-06012-08)
Why genuine Honda bolts?
Many EP3 suspension fasteners are special flanged bolts with specific lengths, shoulders and grades. Genuine parts guarantee the correct fit and strength and avoid the guesswork of matching generic bolts. Fresh, clean threads also make it much easier to achieve accurate torque readings.
Fitting advice
This is the ideal time to change tired components, such as the bushes and mounts or other suspension parts. Support the subframe properly if you are removing its bolts, and replace one fastener at a time where possible to keep the geometry. Tighten bush-mounted bolts with the car at its normal ride height so the rubber is not preloaded, use Honda’s torque figures from the workshop manual, and finish with a full alignment check.
The EP3 shares many chassis fasteners with other Civic models of the same era, but this kit is put together specifically for the Type R front end. Rear suspension bolts are available as a separate set.
