Product Overview
Schroth B 23 Bracket Kit 01324 β Bolt-In Harness Mounting Brackets
Fitting a harness is not always as simple as screwing an eye bolt into the floor. Sometimes the anchor point is in a tight corner, a seat runner is in the way, or an eye bolt would block the seat from sliding. Schroth’s B 23 kit solves this with a pair of low-profile bolt-in brackets that clip on to snap-hook harness ends. It is listed as part 01324 in the hardware and kits section of the Schroth Racing catalogue.
What’s in the kit
- Two B 23 bolt-in brackets
- Swivelling reduction inserts and washers
- Springs and combination washers
- 7/16in shoulder bolts
The inserts and washers let the brackets work with 3/8in, 5/16in, M8 and M10 bolts as well as the supplied 7/16in bolts. That makes it easy to use existing factory seat-belt threads or new mounting points.
Approval and use
Schroth states that the hardware kit is not part of the harness homologation. If you compete, check with your series or scrutineer that this mounting method is allowed, and always follow Schroth’s installation instructions for belt angles and anchor strength. For road and track-day cars it is a neat way to mount snap-on harness ends without losing seat adjustment.
Fitting advice
Mount the brackets only into a structural anchor point or a properly reinforced plate, never thin floor panels alone. Torque the bolts as the vehicle or Schroth instructions specify and check that the snap hooks lock fully and can pivot freely in line with the webbing. Browse our full range of motorsport safety equipment for harnesses, seats and related hardware.











