Product Overview
Tegiwa Carbon Fibre Engine Slam Panel Cover T-C-SLAMCOV-FK2 for Honda Civic Type R FK2 (2015-2017)
The slam panel cover runs across the front of the FK2 engine bay, right where your eye lands when the bonnet opens. Tegiwa’s carbon fibre version replaces the standard plastic trim with a hand-crafted gloss panel that follows the factory profile, tidying up the front of the bay and pairing well with other carbon dress-up parts.
Construction and finish
The panel is made from Grade A carbon fibre sourced from Japan and laid up by hand. A high-gloss lacquer with UV protection keeps the weave looking deep and helps prevent the fading and clouding that can affect carbon parts left in the sun. As with most carbon trim, it is lighter than the part it replaces.
- Grade A carbon fibre, hand-crafted
- High-gloss lacquer with UV protection
- OE-style profile and fitment
- All holes in place for the genuine Honda mounting hardware
Fitment
The cover is listed for the 2015-2017 Honda Civic Type R FK2, and Tegiwa also lists it for non-Type R models of the same generation. It is designed as an OE-fit replacement, with every mounting hole needed to accept the genuine Honda fixings, so no drilling or trimming should be required. Tegiwa does not state that fixings are supplied, so plan to reuse the originals and replace any clips that break during removal.
Fitting advice
With the bonnet open, release the clips or fasteners holding the standard slam panel cover and lift it away. Check the clips for damage, then position the carbon cover, align it with the mounting points and refit the fixings evenly without overtightening, as excessive force can mark the lacquer around the holes. Clean it with a non-abrasive product suitable for lacquered carbon. More information is on the Tegiwa FK2 carbon slam panel cover product page.











