Product Overview
Schroth Harness Reinforcement Plate 00080 β 50 x 80 mm with 7/16″ Welded Nut
When a harness is mounted at a point the vehicle manufacturer never designed as a belt anchor, the eyebolt needs a backing plate behind the panel so the load is spread over a wider area. The Schroth 00080 reinforcement plate does exactly that. It is listed in the Schroth Racing catalogue as a 50 x 80 mm plate with a welded 7/16″ nut, ready to accept a standard 7/16″ harness eyebolt.
What it does
Fitted on the underside of the floor or behind a cage mount, the plate sits against the panel and the eyebolt threads into its captive nut from the cabin side. In a heavy impact, this helps prevent the anchor pulling through thin sheet metal. Because the nut is welded to the plate, you do not need access to hold a loose nut while tightening.
- 50 x 80 mm high-strength steel plate
- Welded 7/16″ nut to suit standard harness eyebolts
- For custom harness anchor points without factory mounts
- Compatible with Schroth eyebolts and snap-on harness fittings
What you need
The plate is sold singly, and a typical harness installation uses several anchor points, so check how many your belt layout requires. Eyebolts and the harness itself are sold separately; you will find harnesses and related parts in our motorsport safety equipment range.
Fitting advice
Harness anchor positions and angles matter for safety, so follow the harness manufacturer’s installation instructions and any rules from your championship or scrutineers. Drill cleanly, deburr the hole, apply corrosion protection to bare metal and ensure the plate sits flat against a solid section of the floor. If you are unsure, have the work carried out by a motorsport preparation specialist. The part is listed under hardware in the Schroth Racing product catalogue.













