Product Overview
Tegiwa Carbon Fibre OEM Bonnet T-C-OEM-FN2 for Honda Civic Type R FN2 (2007-2011)
This is Tegiwa’s OEM-style carbon fibre bonnet for the FN2 Civic Type R. It keeps the factory profile and shut lines, so the car looks standard from a distance while the exposed weave gives the front end a clear motorsport flavour. Swapping the factory panel for carbon also takes weight off the very front of the car, which is welcome on a track day and on a hot hatch that already carries most of its mass over the front wheels.
Construction and finish
Tegiwa hand-lays each bonnet using what it describes as Grade A carbon fibre sourced from Japan. The outer surface is finished in a high-gloss coating with UV protection, intended to stop the weave yellowing or fading in sunlight. Full details are on the Tegiwa FN2 OEM carbon bonnet product page.
- OE shape for a factory-looking fit
- Pre-drilled, threaded mounting points that use the original hinge locations
- Latch fitted to work with the standard bonnet catch
- High-gloss, UV-protected clear finish
Fitment notes
Tegiwa lists this bonnet for the Honda Civic FN2 built from 2007 to 2011, which is the European-market Civic Type R hatchback. It is not listed for the non-Type R FK/FN Civic of the same era, so check with us before ordering for one of those cars. Washer jets, bonnet seals and the insulation pad, if you use one, are transferred from your old bonnet and are not included.
Fitting advice
Fitting is a two-person job. Support the bonnet while removing the hinge bolts, then offer the new panel up loosely and adjust it for even gaps against the wings and headlights before tightening. Close it gently the first few times and check that the latch engages fully and the safety catch holds. Carbon panels are less forgiving of slamming than steel, so lower the bonnet and press it shut rather than dropping it from height. Clean with a non-abrasive car shampoo and protect the gloss with a quality wax or sealant, just as you would painted bodywork.










